1. The first step is to separate the film and attached liner from the clear cap sheet.

2. Spray the painted surfaces where the film will go with soap (or shampoo) solution.

3. Remove the white liner from the film, and spray the exposed adhesive with soap solution.

4. The film is then positioned on the car and the top side is sprayed with soap solution

5. The next step is to spray water-alcohol solution under the film at the starting position

6. Then squeegee the film down at that start position to tack it in place.

7. Spray the outside of the film again with the soap solution.

8. Then squeegee the film from the start position upwards and outwards towards the edges

9. Stretching the film with the palm of the hand, as necessary to fit the part to the car.

10. The final step is to seal and dry the film edges with a hard card wrapped in a paper towel.

The following guidelines will help avoid some common installation problems.

- Work in a dust-free environment with little or no wind, and out of direct sunlight.

- Make sure the painted surfaces to be covered are both clean and dry.

- Use all the appropriate application tools as described in the ‘Tools’ section above.

- Pre-mix the soap solution and the water-alcohol solution ahead of time.

- Remember KSG PPF is elastic and forgiving - you can lift and reposition it as needed, there is no reason to rush the installation.